User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Maintenance
User's Manual 6-5
MAINTENANCE
CAUTION
Do not turn the ribbon feed knob in counterclockwise direction..
6. Verify that the power to the printer is off.
(Make sure that the circle mark on the power switch is pressed.).
Installing the ribbon cartridge
7. Move the paper thickness lever to the D position.
8. Open the front cover.
Turn the knob
clockwise.
5. Using the procedure below, release the roller from the LOCK position
and turn the ribbon feed knob clockwise to take up any ribbon slack.
Push in the gray ribbon release tabs on the side of the ribbon cartridge
to release them, and slide the roller from the LOCK position to the
FREE position.
Ribbon feed knob
Preparing the ribbon cartridge
Roller
Release
tabs