User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
User's Manual
7-3
Trouble-
shooting
TROUBLE-SHOOTING
Table 7.1 Print Quality Problems and Solutions (Cont.)
Problem Solution
Printing is Use the printer’s V-ALMNT function to
vertically check the vertical print alignment. If necessary,
misaligned adjust the print alignment. See the section
(jagged). Using the Diagnostic Functions in Chapter 5.
The top margin is The top margin is the sum of the top-of-form
wrong. setting, the software-specified top margin, and the
printer’s TOP-MRG setting. Proceed as follows:
• Make sure that the top-of-form setting is
correct. The factory default is 25.4 mm (1
inch). See the section Changing Top-of
Form in Chapter 5.
• Check the software-specified top margin.
Refer to your software documentation.
• Check the printer’s TOP-MRG setting. See
the section Changing MENU1 and MENU2
Options in Chapter 5.
Lines are double Check the line spacing setting in your software.
spaced instead of
single spaced. Change the CR-CODE setting in the printer setup
mode to CR ONLY. See the section Changing
MENU1 and MENU2 Options in Chapter 5.
The printer Change the CR-CODE setting in the printer
overprints on the setup mode to CR & LF. See the section
same line. Changing MENU1 and MENU2 Options in
Chapter 5.
The next print line Change the LF-CODE setting in the printer
starts where the setup mode to LF & CR. See the section
previous line Changing MENU1 and MENU2 Options in
ended instead of Chapter 5.
at the left margin.