User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
User's Manual
7-7
Trouble-
shooting
TROUBLE-SHOOTING
Operating Problems
If any of the errors listed in Table 7.3 occurs, the PAPER OUT LED lights
up, and an alarm beeps, and the printer goes offline.
In such cases, the buttons on the control panel can be used in the same
manner as those when the printer is in the offline state.
Table 7.3 Operating Problems and Solutions
Paper end (PE) error Paper end is detected. (*1) - Insert and load the
paper in the paper tray.
Eject jam error Paper end is not detected - Eject forms or sheets.
even after a large amount - Press the online button
of continuous forms or cut to turn the printer
sheets were ejected. online.
Continuous form/ In continuous form loading - Switch the continuous
cut sheet switch status, the continuous form/ form/cut sheet switch
lever error cut sheet switch lever is lever back to its
switched to cut sheet mode. original position.
In cut sheet loading status, - Remove the loaded
the continuous form/cut paper.
sheet switch lever is
switched to continuous form
mode.
If the error occurs, all
buttons are disabled.
Error name Error description Recovery method