Operation Manual

Color monitor 17F1
A26361-K818-Z100-1-5E19 English - 9
Connecting the monitor
Information on the computer connections is contained in the operating manual for your computer.
!
Please note the information provided in the "Safety" section in the chapter "Important
notes" at the beginning of this manual.
Do not cover the ventilation openings of the monitor.
If you are assembling monitors beside each other, there must be a minimum distance of
30 cm between monitors of the same constructional type, to avoid image distortion. With
different monitors, the distance must be increased, if necessary.
1
2
1= Power connector 2 = Data cable
Ê Be sure that the monitor and the computer are switched off.
!
The computer power plug must be pulled!
The data cable is permanently attached to the monitor. It has a 15-pin D-SUB connector for the
monitor port of the computer.
Ê Connect the 15-pin connector of the data cable to the (active) monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
i
If your computer has two monitor ports ("onboard" screen controller and separate graphics
card), the monitor port for the separate graphics card is usually active.
Ê Plug the power cable supplied into the power connector of the monitor.
Ê Plug the power cable into the monitor connector at the rear of the computer.
Ê Plug the power connector of the computer into a properly grounded mains outlet.