User Manual
Table Of Contents
- Revision History
- Table of Contents
- Target products
- 1 INTRODUCTION
- 2 OVERVIEW OF SIMPLE AV SYSTEM BOARD
- 3 PREPARATIONS
- 4 PROGRAM EXECUTION METHOD
- 5 SUPPORTED MEDIA
- 6 OPERATION METHOD
- 7 SPECIFICATIONS
- 7.1 Hardware
- 7.2 Software
- 7.2.1 Software Block Diagram
- 7.2.2 Software Library
- 7.2.3 System Specifications
- 7.2.4 API Specifications
- 7.2.5 Operation Limit
- 7.2.6 Operation Flow of Entire Application
- 7.2.7 Application State Transition
- 7.2.8 Operation Flow
- 7.2.8.1 Main Processing Function
- 7.2.8.2 USB Task Processing Function
- 7.2.8.3 File System (MDF) Task Processing Function
- 7.2.8.4 HMI Task Processing Function
- 7.2.8.5 AUDIO Play Task Processing Function
- 7.2.8.6 Switch Press Detection Processing Function
- 7.2.8.7 Processing Function After Switch Press Detection
- 7.2.8.8 Touch Panel Touch Detection Processing Function
- 7.2.8.9 Processing After Touch Panel Touch Detection Function
- 7.2.9 File Configuration
AN706-00040-2v0-E
12
3.4 Power Supply Method
USB bus power of the PC is used as the power supply for the simple AV system board.
Connect the Type A side of the USB cable (with Type A - Type B connector) to the USB
port of the PC and connect the Type B side to the USB power supply connector of the simple
AV system board.
Press down the power switch with the USB cable connected. The power supply switch is
self-locking and stays depressed while the power is on. To turn the power off, press the
power switch again.
Select your favorite music!
USB Connector for Power Supply
USB Cable (B Connector Side)
Figure 7 USB Cable Insertion Position for Power Supply