User Manual
Table Of Contents
- Revision History
- Table of Contents
- Target products
- 1 INTRODUCTION
- 2 OVERVIEW OF SIMPLE AV SYSTEM BOARD
- 3 PREPARATIONS
- 4 PROGRAM EXECUTION METHOD
- 5 SUPPORTED MEDIA
- 6 OPERATION METHOD
- 7 SPECIFICATIONS
- 7.1 Hardware
- 7.2 Software
- 7.2.1 Software Block Diagram
- 7.2.2 Software Library
- 7.2.3 System Specifications
- 7.2.4 API Specifications
- 7.2.5 Operation Limit
- 7.2.6 Operation Flow of Entire Application
- 7.2.7 Application State Transition
- 7.2.8 Operation Flow
- 7.2.8.1 Main Processing Function
- 7.2.8.2 USB Task Processing Function
- 7.2.8.3 File System (MDF) Task Processing Function
- 7.2.8.4 HMI Task Processing Function
- 7.2.8.5 AUDIO Play Task Processing Function
- 7.2.8.6 Switch Press Detection Processing Function
- 7.2.8.7 Processing Function After Switch Press Detection
- 7.2.8.8 Touch Panel Touch Detection Processing Function
- 7.2.8.9 Processing After Touch Panel Touch Detection Function
- 7.2.9 File Configuration
AN706-00040-2v0-E
18
4.1.3 Program Execution Using Debugger
When the debugger is activated, the screen appears as shown in Figure 15. Press
“Execute” to start executing the program.
Execute
Figure 15 Screen When Debugger is Activated
For other debugger operations, see help.
4.2 Standalone Program Execution
When the program is exported and debugging is completed by the procedure given in “4.1
Program Execution Using Debugger,” turn the board's power off with the power switch and
remove ICE from the simple AV system board.
After doing so, the program is run by standalone by turning the power on with the power
switch on the simple AV system board.