User Manual
Table Of Contents
- Revision History
- Table of Contents
- Target products
- 1 INTRODUCTION
- 2 OVERVIEW OF SIMPLE AV SYSTEM BOARD
- 3 PREPARATIONS
- 4 PROGRAM EXECUTION METHOD
- 5 SUPPORTED MEDIA
- 6 OPERATION METHOD
- 7 SPECIFICATIONS
- 7.1 Hardware
- 7.2 Software
- 7.2.1 Software Block Diagram
- 7.2.2 Software Library
- 7.2.3 System Specifications
- 7.2.4 API Specifications
- 7.2.5 Operation Limit
- 7.2.6 Operation Flow of Entire Application
- 7.2.7 Application State Transition
- 7.2.8 Operation Flow
- 7.2.8.1 Main Processing Function
- 7.2.8.2 USB Task Processing Function
- 7.2.8.3 File System (MDF) Task Processing Function
- 7.2.8.4 HMI Task Processing Function
- 7.2.8.5 AUDIO Play Task Processing Function
- 7.2.8.6 Switch Press Detection Processing Function
- 7.2.8.7 Processing Function After Switch Press Detection
- 7.2.8.8 Touch Panel Touch Detection Processing Function
- 7.2.8.9 Processing After Touch Panel Touch Detection Function
- 7.2.9 File Configuration
AN706-00040-2v0-E
83
7.2.8.2 USB Task Processing Function
After detecting USB device connection/disconnection, the processing shown in Figure 58
is executed.
(av_demoapp_usb_task)
Start
USB device connection event
occur and disconnection event
not occur
Clear USB device disconnection event.
USB device
disconnection event occur
Set USB connection to USB device
connected state.
Clear USB device disconnection event.
Set USB disconnection to USB device
connected state.
Yes
No
USB host driver polling processing
(USBH_Polling)
Finish
No
Yes
LED off
(LED_Set)
Figure 58 USB Task Processing Function Flow