- FUJITSU OPERATION MANUAL network adapter LQFP-64P

i
PREFACE
Thank you for purchasing the LQFP-64P*
1
header type 2 (MB2198-304) for the DSU-FR emulator.
This product is used together with the BGA-660P adapter for the DSU-FR emulator (MB2198-
300)*
2
to connect the DSU-FR emulator (MB2198-01)*
3
and DSU-FR cable (MB2198-10)*
4
to a
user system that uses a MB91460 series Fujitsu FR*
4
microcontroller (LQFP-64P)*
5
.
This manual describes how to use the LQFP-64P header type 2 for the DSU-FR emulator. Please read
the manual carefully before using. Please contact your Fujitsu sales or support representative for de-
tails on which production and evaluation MCU models can be used with this product.
*1 : The lead pitch of package (FPT-64P-M23) is 0.65mm and the body size is 14mm × 14mm.
*2 : Referred to as the “adapter”
*3 : Referred to as the “emulator”
*4 : Referred to as the “DSU cable”
*5 : FR is an abbreviation of FUJITSU RISC CONTROLLER and is a product of Fujitsu Limited.
■ Handling and usage
The handling and use of this product and notes regarding safety use are included in the hardware
manual of the DSU-FR family emulator.
Follow the instructions in for the use of this product.
• DSU-FR EMULATOR MB2198-01 HARDWARE MANUAL
• DSU-FR EMULATOR DSU-FR CABLE MB2198-10 OPERATION MANUAL
• DSU-FR EMULATOR BGA-660P ADAPTER MB2198-300 OPERATION MANUAL
■ Caution of the products described in this manual
The following precautions apply to the product described in this manual.
CAUTION
The wrong use of a device will give an injury and may cause malfunction on cus-
tomers system.
Cuts
This product has parts with sharp points that are exposed. Do not touch edge of
the product with your bare hands. There is a possibility that it may be injured.
Damage
When connect the header board to the user system, correctly position the index
mark (▲) on the NQPACK mounted on the user system with the index mark (▲)
on the header board, otherwise the emulator system and user system might be
damaged.
Damage
When mounting a mass production MCU, correctly position pin 1, otherwise the
mass production MCU and user system might be damaged.