User Guide

Management Commands Command Reference
Intelligent Blade Panel Module
172
7.5 Management Commands
7.5.1 Network Commands
7.5.1.1 show ip interface
This command displays configuration settings associated with the IBP's network interface. The
network interface is the logical interface used for in-band connectivity with the IBP via any of
the IBP's front panel ports. The configuration parameters associated with the IBP's network
interface do not affect the configuration of the front panel ports through which traffic is switched
or routed.
Syntax
show ip interface
Default Setting
None
Command Mode
Privileged Exec
Display Message
IP Address: The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0
Inband Administration VLAN ID: Specifies the inband administration VLAN ID.
7.5.1.2 show ip redirects
This command displays IP default gateway for this IBP.
Syntax
show ip redirects
Default Setting
None
Command Mode
Privileged Exec