Installation Instructions

• Place the handle on top of the holes and insert the screws

through the panel and into the threaded receivers in the

handle [ 2 ].

• Snug ﬁrmly but do not over tighten as damage may occur

to the handle or the panel

5.6 Mounting panels to the door and the

drawer

NOTE

Once all brackets and small brackets have been applied

to the panels, you can begin installing the bottom drawer.

Operate as follows:

• Partially tighten the screw to the receiver [ 1 ].

• Hook the bottom drawer panel starting from the

adjustment bolts on the bottom [ 2 ].

• It is now possible to align panels to adjacent cabinets in

height using the lower alignment brackets, [ 3 ] tightening

or untightening the screws into position as needed. With

the screw slighty tightened, move the panel sideways to

align it to the other panels on the unit or other adjacent

structures.

Set the bottom adjustment bolts using the lock nut once

you are happy with the height alignment.

• Depth alignment: working from the inside of the drawer,

after lifting up the magnetic seal, adjust the panel position

in the Z-direction by adjusting the shoulder bolts and

setscrews with the 4mm hex key in conjunction with each

other ﬁnally locking each mounting position in place [ 4

& 5 ].

• Hook the panel to the ﬁxing devices starting from the top

aligning brackets [ 6 ].