Installation Instructions

100 (4”)

Professional Series:

Ventilation is insured by a forced air system through a grille

located in the upper part of the appliance. This grille should

never be covered by panels or any other devices that could

reduce its efﬁciency. Please refer to page 5-6 to ensure

correct air circulation.

7.4 Post installation checklist

Check that the front levelling feet have been properly

installed.

Check that the connection to the water system does

not have any leaks and that the shut-off valve is easily

accessible.

Check that the electrical connection is correctly installed

and that the socket and / or breaker are easily accessible.

Check the perfect alignment of the appliance with

adjacent structures.

Check that all adhesive tape and external or internal

temporary protective devices have been removed.

Check the perfect closing of the doors and the smooth

sliding of the drawers and shelves.

7.5 Start up

• To start the appliance, connect the plug to the electrical

mains: at this point, when opening the door, the control

panel will usually visualize the message “Stand by”, and

all the panel keys be off

• To turn on all the appliance compartments, press the Unit

button for three seconds. The display will show the

message “Initial test” for approximately 2 minutes. After

this phase the compressors will start up and remain on

until the compartment set temperatures are achieved. Do

bear in mind that this condition could last several hours

during which time the display will continue to ﬂash the

‘Start Up Phase’ message.

• If the appliance is provided with an Ice Maker, prior to

switching it on make sure that the water ﬁlter cartridge is

installed (unless water supply source is already ﬁltered by

other means such as reverse osmosis).