Installation Manual

ManualsBrandsFulton ManualsAutomotiveF2 Two-Speed Trailer Winch with Strap - 3200 lb. Load Capacity - Silver And Black - one size

F3647 (Rev-B 19169) 05/13

Handle

Bolt

Adjustable

Winch Handle

Lock

Washer

Small Flat

Washer

Large Flat

Washer

Cap

Bolt

Lock Washer

Handle

Installation

Installing Handle Roller Assembly:

Assemble handle assembly as shown and torque locknut to 20-25 ft-lbs., using a 9/16” socket.

Adjustable Handle (6” to 9” and Right or Left Hand Drive):

This handle can be mounted not only in different length configurations, but also in a right or left hand orientation. In order to switch to a right or left hand

drive first remove the bolt and washers from each side of the drive shaft. Push the hex shaft 1/2”-3/4” through to the other side. Do not try to remove the

shaft completely in order to keep the internal gears and bushings inline. Place the handle bolt and washers on the handle side and torque to 22-25 ft-lbs.

Then repeat for the opposite side of the shaft. Do not over torque.

Attaching Winch Strap:

Use strap anchor provided with winch as pictured above. Pass the strap loop under the cross bolt, insert strap anchor in the strap loop, then pull tight.

Always maintain a minimum of three complete wraps of strap on the drum.

• Purchaser/owner must ensure that product is

installed according to these instructions.

Purchaser/owner must not alter or modify the

product.

• Operator and bystanders should never position any

part of body under or on the path of any portion of

this product or the load being supported, or

moved.

• Do not allow children to play on or around this

product or the load being supported, or moved.

• Do not use winch to move humans.

• Never exceed the maximum rated capacity. Refer

to stamped markings on top of winch to obtain

rated capacity. If uncertain, contact Cequent

Trailer Products at 1-800-632-3290 or

www.cequentgroup.com

▪ Capacity is based on direct line pull on third layer

of the strap on the drum. Capacity is reduced as

strap builds up on the drum.

• Never stand along side winch or guide the strap

with your hands.

•Never operate with slippery, wet, or oily hands and

always maintain a firm grip on the winch handle.

▪ Do not attempt to stop a winch by grabbing the

handle while in motion.

• Always maintain a minimum of three layers of

strap on the drum.

• A loud clicking sound from the ratchet must be

heard when pulling the load. If properly engaged

and loud clicking sound is not heard, do not use

and replace ratchet components immediately.

• Never release the crank handle unless the ratchet

plunger is fully engaged and the load is supported.

• Winch will not hold the load when load is being

let out.

• Winch is designed for manual operation only and

the load rating is based on an intermittent duty

cycle.

• Excessive force in turning winch handle may

indicate overload. Fulton brand winches will

require a max of 45 lbs of handle force to pull

rated load.

• If you cannot crank the winch with one hand you

are potentially overloading the winch.

• Winches are not designed to secure boats to

trailers while towing. Boat tie downs must be

used for this purpose.

• Periodically check mounting hardware for proper

torque and tighten if necessary.

▪ Do not use cable or rope.

• Always replace bent, broken, or worn parts before

using this product.

• On two-speed winches, make sure that the ratchet

plunger is properly engaged and holding the load

before attempting to change gears.

Failure to follow these warnings and instructions may result

in property damage, serious bodily injury, and/or death.

WARNING

The mounting surface must be equal to or greater than the footprint of the winch frame. When attaching the trailer winch, use the three (3) supplied 3/8”

dia. grade-5 carriage bolts/lock nuts and torque to 28-30 ft-lbs. Check final installation and make sure winch is secure to mounting structure.

Installation Instructions

Warning: Failure to follow all installation instructions could result in

winch failure.

Read, understand and follow all of these instructions and warnings (Instructions) before installing and using this product. Install and use this product only

as specified in these instructions. Improper installation or use of this product may result in property damage, serious injury, and/or death. Never allow

installation or use of this product by anyone without providing them with these instructions. You must read, understand and follow all instructions and

warnings for any product(s) to which this product is used in conjunction with or installed. Save these instructions with the product for use as a reference

for any future installation and use of the product.

Read, Understand, Follow and Save These Instr uctions

Strap

Installation

Cross

Bolt

Strap

Loop

Strap

Anchor

Trailer Winch

Handle Roller

Assembly

Winch

Mounting

Summary of content (10 pages)

PAGE 1
Trailer Winch Read, Understand, Follow and Save These Instructions Read, understand and follow all of these instructions and warnings (Instructions) before installing and using this product. Install and use this product only as specified in these instructions. Improper installation or use of this product may result in property damage, serious injury, and/or death. Never allow installation or use of this product by anyone without providing them with these instructions.
PAGE 2
Prior to Use - Inspect strap and replace if damaged. - Check mounting hardware for proper tightness and re-torque if necessary. - Gears, ratchet contact points and shaft bushings must be kept lubricated with a thin oil or grease. Operation Strap Under Drum Engaged Strap Over Drum Let Line/Load Out: Before turning the handle, firmly grip the winch handle and disengage the ratchet plunger or engage it in the reverse direction.
PAGE 3
Treuil de remorque Lisez, assimilez, suivez et conservez ces instructions Lisez, assimilez et suivez ces instructions et avertissements (Instructions) avant d'installer et d'utiliser ce produit. Installez et utilisez ce produit uniquement comme il est indiqué dans les instructions. La mauvaise installation ou utilisation erronée de ce produit peut donner lieu à des dégâts, des blessures et/ou la mort.
PAGE 4
Avant d'utiliser - Inspectez la sangle et remplacer si elle est endommagée. - Vérifiez le matériel de montage pour une bonne fermetée et reserrez si nécessaire. - Les engrenages, points de contact des cliquets et douilles d’arbre doivent être toujours lubrifiés avec une huile fine ou de la graisse. Utilisation Sangle sous le tambour Engagé Ligne détendue /Dérouler: Avant de tourner la poignée, manipulez et dégagez le cliquet piston dans le sens inverse.
PAGE 5
Anhaenger Winde Lesen, Verstehen, Folgen und Heben Sie diese Anleitung auf Lesen, verstehen und folgen Sie allen Instruktionen und Watnungen, bevor Sie dieses Produkt installieren und benutzen Installieren und benutzen Sie dieses Produkt nur wie in diesen Instruktionen vorgeschrieben. Falsche Installation oder Benutzung dieses Produkts kann zu Sachschaeden, ernsthaften Verletzungen und / oder Tod fuehren. Erlauben Sie niemandem die Benutzung oder Installierung dieses Produktes ohne diese Anleitung.
PAGE 6
Vor dem Benutzen - Inspizieren Sie den Strap und tauschen Sie ihn aus wenn noetig - Ueberpruefen Sie die Montage und ziehen Sie sie nach wenn noetig.. - Gaenge, Ratschenpunkte und Muffen muessen mit einem duennen oel oder Schmiere geoelt werden. Bedienung Strap Unter Tonne Eingerastet Leine / Ladung auslassen Bevor Sie den Griff drehen, greifen Sie den Windengriff und loesen die Ratschensperre oder setzen sie in die andere Richtung.
PAGE 7
Cabrestante para Remolque Por Favor Lea, Comprenda, Siga y Guarde Estas Instrucciones Lea, comprenda y siga todas las instrucciones y advertencias (Instrucciones) antes de instalar y usar este producto. Instale y use este producto solamente según lo especificado en estas instrucciones. La instalación o uso inapropiado de este producto puede causar daños materiales, lesiones graves, y/o muerte. Nunca permita la instalación o uso de este producto por alguien sin antes haberle provisto de estas instrucciones.
PAGE 8
Antes de Usar - - Inspeccione la correa y reemplácela en caso de daños. - Revise el ajuste apropiado de los accesorios de montaje y ajuste nuevamente en caso de ser necesario. - Los engranajes, los puntos de contacto del pulsador y las bridas del eje deben mantenerse siempre lubricados con un aceite suave o con grasa.
PAGE 9
Trailer Winch Lees, begrijp, volg en bewaar deze instructies Lees alle instructies en waarschuwingen (Instructies) goed door, zorg dat u ze begrijpt en volg ze op, alvorens dit product te installeren en te gebruiken. Installeer en gebruik dit product alleen op de wijze zoals omschreven in deze instructies. Onjuiste installatie of onjuist gebruik van dit product kan schade aan eigendommen, ernstige verwondingen en/of de dood tot gevolg hebben.
PAGE 10
Vóór gebruik - Controleer de kabel en vervang deze indien beschadigd . - Controleer het bevestigingsmateriaal op de juiste torsie en haal nogmaals aan indien nodig. - Drijfwerk, contactpunten van palrad en naafmantel moeten altijd gesmeerd zijn met dunne olie of vet. Bediening Kabel onder trommel Ingeschakeld Neutraal Kabel/Gewicht laten zakken: Zorg voor een stevige greep op de lierhendel alvorens de hendel te draaien en maak de palradvergrendeling los of zet het vast in tegengestelde richting.