Assembly Instructions . ASSEMBLY RATING The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY, PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in Position each past correctly and insert Use cardboard or carpet area when an assembly, please make sure the resews or bolts into their respective assembling furniture to prevent lock or spring washer is placed holes by hand tighten or using the scratches .
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. =NNN Parts List #1 x 1pc Head Board (Left) #2 x 1pc Head Board (Right) s #3 x 1pc Bottom Back Rail Panel .
Parts List #9 x 1pc Top Front Attached Guardrail #10 x 1pc Bottom Front Attached Rail 1pc Top House Center support #12 x PCs Top House Panel 1pc Center Rail Support slat X PCs Leg Support Slat 310 1st Completed Twin Slat 14pcs/iset #12 L #2 Page 4 of 10
#A x 4 Set #B x PCs #G x apes #B 2) Align back rail (#3) (o (he holes of the headboards Source by using bolts 3) Insert dowels to cache cnd of back rail Align buck il (#5) to the boles of the headboards Secure by using boils >\ 1) Insert barrel nuts (#A) to back rail Align back rail (#3) lo the holes of the headboards Secure by using bolts (#A) onto barrel nuts FULLY TIGHTEN ALL BOLTS ONCE THIS STEP IS DONE.
Align right window panel (#8) to (he holes of the front rails Secure bottom holes by using boils (#C) and topside holes by using boils #C x Bps 11psc Align gift window panel (#7) 1o the holes of the front Tails Secure bottom holes by using obits (#C) and top/side holes by using boils (4D}, Align front attached guardrail (#9) to the top of the house. Secure by using boils Align front attached rail (#10) lo the bottom of the house. Scare by using bolts (D).
Align top center support (#11) 10 the 10p holes of the house.
Secure (he bottom half of the top house panels (#12) by using screws #F x PCs Adjust leveler of the support legs (#14) according to ground level, T "#14 Almach support legs (#14) 1o (he center rail support slat Page 8 of 10
Align slats (#15) 10 the side rails and center support slat inside the house. Source by using scows (4F).
186, Safely Warnings for Bunk Beds Read and follow the information on the WARNINGS shown o the end structure of the upper bunk and on the carton. Bo not remove warning label from the bed. Keep these instructions for future reference. IMPORTANT Must use Junkie mattress or Junkie board. The proper sizes for the SUPERPOWER TWIN.