ASSEMBLY INSTRUCTIONS VERSION # 18-01-17 TOOLS REQUIRED BE Phillips Screwdriver {Not Included) —— Hammer {Not Included) «Persons Recommended WIST 000°C EASY me DIFFICULT The Assembly Rating is a S-point system showing the seven of effort needed to assemble a specific product.
CHECK BEFORE STARTING Are you missing anything? Double-check all parts, hardware and accessories listed on Page 6 are accounted for. Should we send any replacements? Are there any irregularities ar flaws in the pairs? We can send replacements! Check out our Quick Tips! We recommend reviewing the per-assembly handouts. Even experts need a refresher now and then! Prep Time! Please review the assembly instructions and all diagrams prior to assembling.
PRE ASSEMBLY INTRODUCTION We understand building ready-to-assemble furniture can be a challenging experience for some. To help avoid confusion, we have provided some helpful tips that may speed up the process. Teamwork ALWAYS have at leas! two people to help with transporting and assembling the product to avoid potential injury and/or damage. O = | bated | Suitable Location Assembling near the area of the intended location is highly recommended.
ASSEMBLY AND CARE ADVICE A FAILURE TO FOLLOW THE GUIDELINES BELOW MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. Tum clockwise to tighten and only tighten when step is completed or when instructed Position each part correctly and insert screws or bolls into their respective holes. to do so, Use the appropriate hand tools ar power tools Tor assembly. Select steps, such as tightening straws and/or bolts, may require hand tools to avoid causing % fs damage during assembly.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Note ; «1 Every cam lock bolt must have a cam Nag, lock connector in order fo fasten the parts together. cam bolt cam lock screwdriver Screw the cam bolt into panel. Align the cam lock with its side opening (or arrow) pointing to cam bolt. insert the cam Holt into the bolt hole of joint panel, Tum the cam lock clockwise gently until it will not turn any more.
ASSEMBLY INSTRUCTIONS 1 Hardware (I) x16PCS LD Hardware (3) PCs | 5 Hardware (8) PCs Hardware PCs Apply a dab of glue into sows holes of pansies before inserting dowels wn ol #5 HOLE USAGE Align screws with the darkened holes in the above diagram, “Depth Adjustment Length Adjustment.
ASSEMBLY INSTRUCTIONS 2 Hardware (1) PCs ay rE @ Hardware (3) x14PCS u Tw #5 Hardware (8) PCs Hardware PCs Apply a dan of glue #2 into dowel holes of @ panels before Inserting fowls (43).
ASSEMBLY INSTRUCTIONS 3 Hardware (1) PCs Hardware (3) PCs Part § x1PC Part {@ x1PC Part & x1PC Part {8 x1PC Part @) x1PC Hardware &) PCs Hardware (4) PCs Please refer to page § for detailed instructions on how to fasten cam lack (#2) to cam bolts Apply & dab of slug into dowel holes of panes before inserting dowers (3).
ASSEMBLY INSTRUCTIONS Hardware (8) PCs Fully extend drawer ra align tha rail’s smallest hole to tha drawer little panel's holes.
ASSEMBLY INSTRUCTIONS 17 Accessory (AB) x1PC Accessory (a7) x1PC Accessory [A8) sextet For safety, please secure Lin tit root wall by using wall mounted straps provided. Refer to page 18 on wall muting guide © Keep this handy! Please retain this instruction manual and any order relate information for fusee reference.
ASSEMBLY INSTRUCTIONS Wall Mounting and el EXPANSION WALL ANCHOR Cur provided expansion wail anchors are only suitable for masonry walls, such as drywall, plaster or concrete, and are best for holding lightweight items or for anti-tip prevention. If you are unsure of the correct wall anchor to use with the product, please request professional guidance. liability for product damage or failure due to using the incorrect anchors will fail on the installer.