Installation Instructions

12
Initial Activation:
1. Power the receiver and confirm solid red LED for approx. 1 minute. This is
followed by a solid amber to flashing amber to solid green to finally a flashing
green LED [additional 0.5 minutes]. At this point the software is fully loaded and
system is ready.
2. Turn on your display [refer to your individual user guide/ handbook for detailed
information].
3. Contact Sirius to “activate” your system. (1-800-869-5480)
Reminder: have your serial number available (Data ESN) which is
marked on the underside of your receiver. Note: Should you see
actual weather data displayed prior to “activation”, this is only
the balance of the manufacturers [time limited activation which
was used for testing purposes at the factory] and does not reflect
that your personal “activation” is in place.
Operation:
1. With the system and your display powered ON.
2. It may take up to 30 minutes before the system is populated with weather data.
3. Open a weather application page on your display and make it active. [For full
details of how to carry this out, refer to the relevant display handbook supplied
with your equipment.]
4. One of your first actions will be to locate and record your own personal Sirius ID
number.