Users Manual Part 2

1. INSTALLATION
1-13
4. Fasten the antenna radiator to the radiator bracket from the bottom of the bracket
with the eight hex bolts, spring washers and flat washers. The torque must be 49
N•m.
5. Coat the bolt heads fastened at step 4 with the sup-
plied adhesive as shown in the figure to the right.
6. Connect the coaxial cable from the antenna unit to the rotary joint. The torque
must be 25 N•m.
Note 1: The coaxial cable connector must be connected vertically.
Note 2: The coaxial cable must be horizontal and must not contact the antenna
support hole.
Note 3: If the coaxial cable is long, bend the cable some distance from the con-
nector. Insert surplus cable into antenna support. Connect the cable to the rotary
joint, taking care that the threads of the cable and rotary joint are aligned.
7. Coat the hex bolts (M1240, 4 pcs.) for the support cover with the supplied adhe-
sive).
8. Fasten the support cover with the hex bolts, spring washers and flat washers. The
torque must be 20 N•m.
Note 1: Make sure the safety rope does not contact the antenna support cover.
M12 bolts (eight places)
Hex bolt
Flat washers
Spring washers
BracketBracket
Coat with adhesive
Adhesive
1) Keep the cable straight.
2) Connect the cable connector vertically.
1)
2)
Hole in the antenna support
Antenna support cover
Left when viewed from the front side
Safety rope
Hex bolt
(four places)
Front viewFront view