Users Manual Part 2
1. INSTALLATION
1-10
Mounting platform side
Arrange a ground terminal as close as possible to antenna unit. There are two
methods to connect the ground wire for mounting platform side.
1.1.7 How to fasten the antenna unit to the mounting platform (FAR-
2x58)
1. Construct a suitable mounting platform referring to the outline drawing at the end
of this manual.
Note: The mounting platform must be flat, level and firmly secured.
2. Lay the rubber mat (supplied) on the mounting platform.
3. Referring to the outline drawing at the back of this manual, drill four mounting
holes (15 mm) and one cable entry hole (50 mm) diameter in the mounting plat-
form.
4. Place the antenna unit on the supplied rub-
ber mats, then orient the unit so the name-
plate on the scanner box is facing the ship’s
bow.
Note: When the antenna unit is placed on
the platform, make sure that the platform is
not inclined.
5. Insert four sets of hex bolts (M1260) attached the seal washers to the mounting
holes of the antenna chassis.
6. Adjust the direction of the antenna unit so the nameplate is facing the ship’s bow.
7. Fasten the antenna unit to the mounting platform with four sets of hex bolts, nuts,
flat washers and seal washers. The torque must be 49 N•m.
Hex bolt
Flat washer
Flat washer
Hex nut
Spring washer
Adhesive
Adhesive
Mounting Platform
Mounting Platform
Ground wire
Ground wire
Welding
Hex bolt
Hex bolt
Spring washer
Flat washer
Mounting Platform
Mounting Platform
Adhesive
Adhesive
Ground wire
Ground wire
Method 1 Method 2
FRONT
Nameplate
Rubber mat
M12×60 (4 places)
Corrosion proof
rubber mat
Two nuts
(Torque: 49 N•m)
Spring washer
Chassis
Chassis
Platform
Platform
Seal washer
Flat washer
Flat washer
Adhesive