Manualshelf

Users Manual Part 5

ManualsBrandsFuruno ManualsElectronicsTransceiver Unit
11121314151617181920
3. TARGET TRACKING (TT)
3-20
3.11.3 How to change the color of TT tracks (C-types only)
You can change the color of the TT tracks with the following procedure.
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [3 TT•AIS SYMBOL].
4. Select [3 TT SYMBOL COLOR].
5. Select the desired color you want to show the TT tracks in.
6. Close the menu.
3.12 Set and Drift
Set, the direction in which a water current flows, can be manually entered in 0.1-de-
gree steps. Drift, also known as “Rate”, or the speed of the current, can also be en-
tered manually in 0.1-knot steps.
When course through water and speed through water are available, activate set and
drift to get course over ground and speed over ground.
Set and drift corrections are beneficial for increasing the accuracy of vectors and tar-
get data. Refer to the tide table on board the ship for setting information. These values
are applied to all targets. If stationary targets have vectors, set and drift values should
be adjusted until they lose vectors.
To enter set and drift do the following:
1. Open the menu.
2. Select [7 INFORMATION BOX].
3. Select [2 OWN SHIP INFO].
4. Select [3 SPEED]. The [SPEED] menu appears.
Note: You can also access the [SPEED] menu from the on-screen box. Place the
cursor on the [SPD ] indication in the speed box at the top-right of the screen,
then right-click.
5. Select [4 SET DRIFT].
6. Select [ON], then press the ENTER MARK key. The setting can now be adjusted
and [SET] is selected.
7. Spin the scrollwheel to select the appropriate setting (Setting range: 000.0° to
359.9°), then left-click. The [DRIFT] setting is now selected.
8. Spin the scrollwheel to select the appropriate setting (Setting range: 00.0kn to
19.9kn), then left-click.
9. Close the menu.
Note 1: Set and drift are available when using manually input speed, speed through
the water. The speed source is shown as "WTC" (Water Tracking Count).
Note 2: Set and drift should be checked periodically for correctness.
Note 3: When speed data input from the position sensor is valid, set and drift are not
adjustable.