Operator's Manual

1. MOUNTING

Sensor Holder

Locknut

Washer

Rubber gasket

Locknut

Washer

Rubber gasket

Apply silicone

sealant.

Apply silicone

sealant.

Sensor Cable

T-02MSB

T-03MSB

Holder guide

21mm (0.83”)

Less than 25 mm (1.0”)

How to install:

1. Drill a 21 mm (0.83”) hole in the ship’s

bottom.

2. Feed the cable up from under the ship’s

bottom.

3. Insert the cable through the rubber gasket,

washer, and locknut, in that order.

4. Apply high quality silicone sealant to the

the surface of the flange, and affix the

sensor with the locknut (do not exceed a

torque of 59 Nm).

5. After launching the ship, check that the

area is free from water leakage.

How to install:

1. Drill a 25 mm (1.0”) hole in the ship’s bottom.

2. Coat the holder guise with a high quality silicone

sealant, and feed the holder guide up through the

ship’s bottom.

3. Place the the rubber gasket, washer, and locknut,

onto the holder guide (from the top down), in that

order.

4. Place the sensor holder onto the holder guide,

then affix with the nut.

5. After launching the ship, check that the area is free

from water leakage.

25mm (1.0”)