Installation Instructions

f) If you don’t see the DRS listed after the initialization, proceed to the following
steps:
g) Click on “START” to begin to update the DRS.
a. Power the DRS OFF and then back ON. This can be done by cutting the
power to the PSU or by disconnecting and then reconnecting the power cable
to the DRS.
b. Wait for 2 minutes.
c. Click “Scan” on the MFD to refresh the list.
2. Update Procedure (continued)
h) At the end of the process, click on “OK” when the message “Ready to shut down to
complete update” appears.
(10)
FURUNO U.S.A., INC.
Camas, WA
[phone]
Denton, MD
[phone]