Operator's Manual

2. DISPLAY CATEGORIES AND CATEGORY SPECIFIC MENUS
2-6
2.7 Timer Category
The Timer category has three available timers to select from, as indicated in the figure
above. To select the desired timer, see "How to set up pages" on page 1-7.
[Countdown Timer1] and [Countdown Timer2] both have a maximum time of 15 min-
utes. The [Trip] indicator on [Countdown Timer2] and on the [Countup Timer] keeps
track of the distance traveled (requires appropriate sensors).
Note: All timers are paused and the normal display indications are restored if the
Menu/Back key is pressed with any timer open.
2.7.1 How to use the timers
With the timer screen displayed, press the function key to show the [Func] key
indications. Press the function key again to start the selected timer.
The [Countdown Timer2] and [Countup] timer begin to measure distance.
With the timer active, press the right software key to record a lap time. Press the left
software key to reset the timer to nearest minute.
Press the function key at any time to stop the timer. The Menu/Back key may also
be used to stop the timer.
With the timer stopped, press the right software key to reset the times (counter and
lap) and distance.
To restart the timer, press the function key.
Time
Trip
00:
00:
00:00
0
00:00
NM
Lap
Time
Trip
00:
00:
00:00
0
15:00
NM
Time
00:
00:00
15:00
Lap
00:
Countdown Timer1
Countup Timer
Countdown Timer2
2
3
3
1
2
1
2
4
3
1
2
4
Trip meter
Countdown Timer
Lap time
Countup Timer