Operator's Manual

3. ALARMS
3-8
3.9 Anchor Alarm
The anchor alarm activates when the vessel exceeds the selected distance from the
point at which the alarm was set, or the depth is higher/lower than the depth threshold
setting. This alarm is useful when at a standstill or not at the helm.
1. Access the [Alarms] menu, using the procedure outlined on page 3-1.
2. Press the software keys to select [Anchor Alarm], then press the function key.
3. [Alarm] is highlighted, press the function key.
4. Select [OFF], [Distance] or [Depth] as appropriate, then press the function key.
• [OFF]: Disable the alarm. Proceed to step 7.
• [Distance]: Activates the alarm when the vessel goes over the distance
threshold.
• [Depth]: Activates the alarm when the vessel goes deeper or shallower than the
depth threshold.
5. Press the software keys to select the threshold, then press the function key.
6. Press the software keys to set the threshold as appropriate, then press the func-
tion key to apply the changes.
7. Press the Menu/Back key twice to close the menu.
Distance threshold
Where Anchor Alarm
is set to [Distance]
Where Anchor Alarm
is set to [Depth]
Vessel position
when alarm is set
Depth at which
the alarm is set.
Depth at which
the alarm is set.
Depth
threshold
Depth
threshold
Seabed
Seabed
Gray
coloring in
this figure
indicates the
alarm
activation
area.
Gray
coloring in
this figure
indicates the
alarm
activation
area.
Anchor Alarm
Alarm:
Buzzer:
OFF
0.00NM
(250ft)+/- 50ft
Short
Select the distance when [Alarm]
is set to [Distance].
Select the depth when [Alarm] is
set to [Depth].
Select the buzzer type when
[Alarm] is set to [ON].