Operator's Manual

4. SYSTEM MENU
4-12
4.9 How to Adjust (Calibrate) Incoming Data
Use the [Data Calibration] menu to adjust offsets for data input to the FI-70.
1. Access the [System] menu using the procedure outlined on page 4-1.
2. Press the software keys to select [Data Calibration], then press the function key.
3. Press the software keys to select the appropriate data to offset, then press the
function key.
The data which can be offset is shown in table below.
4. Press the software keys to select the required offset, then press the function
key.
5. Press the Menu/Back key twice to close the menu.
Adjust (STW) Offset the speed displayed.
Wind Damping Offset the delay between wind sensor and FI-70.
Adjust (W Speed) Offset the wind speed displayed.
W Angle Response Sets the needle response speed. Lower settings give a
faster response (needle movement).
Offset (W Angle) Offset the wind angle.
Offset (HDG) Offset the heading.
Offset (Depth) Offset the depth.
Offset (W Temp. Offset the water temperature.
Data Calibration
Adjust(STW):
Wind Damping:
Adjust(W Speed):
W Angle Response:
1.00(18.0kn)
Ent
----------------
1.00(5.0kn)
0s
0s(20.0kn)
The value after
calibration is shown
in parentheses.