Marine GPS System User Manual

2-2
2.2 Inserting Chart Cards
Note: Insert chart card before turning on the
power. This enables automatic loading of
chart.
1. Open the memory card slot cover at the
bottom of the display unit by unfastening
two screws.
Screws
Cover
Figure 2-2 Display unit, bottom
2. Insert the chart card label side up, arrow
forward.
EJECT
button
Chart
card
Arrow forward
Figure 2-3 How to insert chart card
3. Close the cover and fix it.
Note: Always keep the cover closed to keep
foreign material out of the chart card drive.
2.3 Turning On/Off the Power
Press the POWER key to turn the power on/
off. When the unit is turned on, it proceeds in
the sequence shown in Figure 2-4. About 20
seconds after the start-up sequence is com-
pleted, the GPS receiver status indication
"ACQ" (at the bottom right-hand corner)
changes to 2D (or 3D). ACQ means the re-
ceiver is acquiring the GPS signal, and 2D
(or 3D) means the position data is reliable.
Displayed for
about one second.
Displayed for
about one minute.
BRG+ 232.0° RNG+ 0.00nm ACQ
DEP 110m TMP 16 .0°C 13:41
+ 34°43.801’N 135°21.163’E
GPS Fixing Status
ACQ (Acquiring)
is replaced by
2D or 3D when
position becomes
reliable.
Plotter display
ROM
RAM
VRAM
Battery
Program No.
Base Chart No.
OK
OK
OK
OK
=
02522530**
=
NO NATIONAL HYDROGRAPHIC
OFFICE HAS VERIFIED THE
INFORMATION IN THIS COASTLINE
DATA CARD AND NONE ACCEPT
LIABILITY FOR THE ACCURACY OF
REPRODUCTION OR ANY
MODIFICATIONS MADE THEREAFTER.
THIS PRODUCT WITH THIS
COASTLINE DATA CARD DOES NOT
REPLACE THE REQUIREMENT TO
USE THE APPROPRIATE PRODUCTS
FOR NAVIGATION ACCORDING TO
NATIONAL AND INTERNATIONAL
REGULATONS.
— — WARNING— —
FURUNO ELECTRIC CO., LTD.
** Program version
no.
Figure 2-4 Start-up sequence
2D: Ship's position is calcurated by using data
from 3 satellites.
3D: Ship's position is calcurated by using data
from 4 satellites.