Operator's Manual

8. MENU SETTINGS
8-2
Geodetic Datum
Select the geodetic chart system you are
using. WGS-84 (standard GPS chart system)
and NAD 27 can be directly selected. For
other charts, select "OTHER" and enter chart
number referring to the geodetic chart list in
the Appendix.
To output position data to ECDIS (Electronic
Chart Display and Information System), turn
on the power while holding down the [0] key.
This disables access to the Geodetic Datum
menu. Then, "Cannot be changed" is shown
in the Geodetic Datum menu as in Figure 8-2
on the next page. To stop outputting position
data to ECDIS, turn on the power while
holding down the [0] key.
POSN Offset
You may apply an offset to position
generated by the internal GPS receiver, to
compensate for difference between GPS
position and chart position.
Time DIFF
The GPS system uses UTC time. If you
would rather use local time, enter the
difference in hours between local time and
UTC. Use the numeric keys for times later or
earlier than UTC, respectively.
POSN
When executing cold start there is no
satellite information in the unit’s memory,
thus it may take some time to find position.
To fix position faster, enter estimated
position.
Selecting fix mode
1) Press MENU ESC, 9 and 6 to display the
GPS SETUP menu.
Fix Mode 2D 2/3D
Disable Satellite 12
ANT Height 016 ft
(1-32)
GPS Smoothing
0 0 0 (0000-9999 sec)
SPD 0 0 0 5 (0000-9999 sec)
Speed Average 0 0 6 0 (0000-9999 sec)
To Next Page
GPS SETUP 1/2
MENU : Escape
: Select
ENT : Enter
POSN
0
Figure 8-1 GPS SETUP menu, page 1/2
2) Press
or to select Fix Mode.
3) Press
or to select the fix mode
desired.
4) Press
to change other settings, or
press MENU ESC key to register settings
and escape.
Disabling satellites
1) Press MENU ESC, 9 and 6.
2) Press
or to select Disable
Satellite.
3) Key in satellite number, in two digits
(01-32). Three sets of satellite numbers
may be entered.
4) Press the NU/CU ENT key. If an invalid
number is entered the buzzer sounds.
5) Press the MENU ESC key.
Note: To enable all disabled satellites, press
the CLEAR key at step 3. All satellite
numbers on the Disable Satellite line are
erased.
Entering GPS position smoothing
1) Press MENU ESC, 9 and 6.
2) Press
or to select POSN.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.