Operator's Manual

47
User Controls
OSD Menu Overview
IND100064-39
Management Settings (page 56-61)
Level 1 (Main Menu) Level 2 Level 3 Level 4 Level 5
Management Settings > < Exit
* Graphic Scaling > < Exit
Graphic Scaling > Full Screen,
Fill to Aspect Ratio, 1:1
Zoom > (Slider Bar)
Horizont Stretch > (Slider Bar)
Vertical Stretch > (Slider Bar)
Auto Adjustment > On, Off
*Unknown Timing Search > < Exit
Auto Mode > < Exit
Display Size > 4:3, 5:4, 1:1, 16:9, 16:10
Execute > (Automatic Action)
Blind Mode > < Exit
Hor. Resolution > (Slider Bar)
Ver. Resolution > (Slider Bar)
Total Hor. Line > (Slider Bar)
Hor. Blank Pixels > (Slider Bar)
Ver. Blank Pixels > (Slider Bar)
Execute > (Automatic Action)
Save Timing > Slot 1 to 8 > (Automatic Action)
Clear Timing > Slot 1 to 8 > (Automatic Action)
LED Drive > (Slider Bar)
*GDC Sensitivity > (Slider Bar)
*Filter > On, Off
*VGA Out > Enable, Disable
*VGA SEL > Enable, Disable
*Communication > < Exit
RS232 > (Select)
2-wire RS-485 > (Select)
4-wire RS485/422 > (Select)
Address RS > (Slider Bar)
IP Address > Auto IP > (Select)
Fixed IP > (Number Input, xxx.xxx.xxx.xxx)
Download > (Automatic Action)
Service Settings (page 62-63)
Level 1 (Main Menu) Level 2 Level 3 Level 4 Level 5
Service Settings > < Exit
GEV Firmware Ver > (Text Displayed)
CYP Firmware Ver > (Text Displayed)
Ethernet Ver > (Text Displayed)
Elapsed Time > (Text Displayed)
Current Temp > (Text Displayed)
Fault Status > < Exit
DVI Chip > (Text Displayed)
NVRAM > (Text Displayed)
Ethernet > (Text Displayed)
GDC > (Text Displayed)
TMP Sensor > (Text Displayed)
Test Pattern > (Automatic Action)
Burn In > ON, OFF