Installation Instructions

3. INITIAL SETTINGS

3-23

3.9 Universal Port Setup

The [UNIVERSAL PORT] menu sets up the GENERAL IN and GENERAL OUT ports.

GENERAL IN: A switch box is connected to this port to control the NAVpilot from a remote

location.

GENERAL OUT: A buzzer sounds or a lamp lights at a remote location when the specified

function is done on the NAVpilot.

If you have equipment connected to only the GENERAL OUT port, go to step 5.

1. The cursor is selecting the setting for [IN PORT1]; push the knob.

2. Rotate the knob to select the command or function for [IN PORT1]. This is the com-

mand or function assigned to the switch box connected to this port.

[DISABLE]: The port is disabled.

[AP ENABLE]: Select ON to get full control of the boat with the NAVpilot. In the OFF

setting only the STBY mode is available.

[GO STBY]: The switch, when operated, puts the NAVpilot in the STBY mode.

[GO AUTO]: The switch, when operated, puts the NAVpilot in the AUTO mode.

[PORT ARROW KEY]: The switch, when operated, controls the W key on the NAVpi-

lot.

[STBD ARROW KEY]: The switch, when operated, controls the X key on the NAVpi-

lot.

[NET TOWING AUTO]: The switch, when operated, enables the automatic towing

function when a boat is towing fishing gear. This feature is not available in the follow-

ing case.

• For a sailboat or Fantum Feedback

• When [NET TOWING AUTO] is set to [ON] in the menu for each mode or [AUTO

OPTION] menu

[FUNCTION KEY]: Assign function of equipment connected to NAVpilot. For a sail-

boat, this feature is not available.

UNIVERSAL PORT

IN PORT1: DISABLE

IN PORT2: DISABLE

OUT PORT1: DISABLE

OUT PORT2: DISABLE

DISABLE

AP ENABLE

GO STBY

GO AUTO

PORT ARROW KEY

STBD ARROW KEY

NET TOWING AUTO

FUNCTION KEY