Installation Instructions

1-1

1. HOW TO INSTALL THE UNITS

Note: For how to install the Control Unit FAP-7011C, see the operator’s manual (OME-

72780).

1.1 Control Unit FAP-7001/FAP-7011

• The Control Unit can be installed three ways:

• Surface mount (fixed from front panel or fixed from rear panel (FAP-7011 only))

• Desktop mount, and

• Flush mount (Optional kit required, instructions, supplied separately).

Select a mounting location for the Control Unit, keeping the following in mind.

• Select a location with good ventilation.

• Shock and vibration must be the least possible.

• Use the supplied display hard cover when the system is not in use.

• Do not install the display unit under "Plexiglas" or other type of shielding material. Plexi-

glas can trap heat and moisture or magnify sunlight energy onto the surface of the dis-

play.

• For maintenance and checking purposes, leave space at the sides and rear of the unit

and leave slack in cables. See the outline drawing for recommended maintenance

space.

• Observe the compass safe distances shown in the safety instructions on page i to pre-

vent interference to a magnetic compass.

Control Unit-FAP-7001 Control Unit FAP-7011