Manualshelf

Operator's Manual

ManualsBrandsFuruno ManualsInstrumentsFuruno RD33
51525354555657585960
4. ALARMS
4-7
2. Use the Cursorpad (S or T) to select [Water Temperature] and press the ENT
key.
3. Use the Cursorpad (S or T) to select [Low], [High], [Within], [Outside] or [Shear]
then press the ENT key. When you do not set the water temperature alarm, select
[Off] and go to step 6.
[Low]: Alarm occurs when the water temperature is equal to or lower than the
temperature setting.
[High]: Alarm occurs when the water temperature is equal to or higher than the
temperature setting.
[Within]: Alarm occurs when the water temperature is equal to or within the tem-
perature range setting.
[Outside]: Alarm occurs when the water temperature is equal to or outside the
temperature range setting.
[Shear]: Alarm occurs when the water temperature varies more than the temper-
ature setting within one minute.
4. Use the Cursorpad (X) to move the cursor to the right and press the ENT key.
5. Use the Cursorpad to set the value and press the ENT key. If you selected [Within]
or [Outside] at step 3, set the value for maximum and minimum temperature.
S, T: Select [+] or [-]. Change the figure.
W, X: Move the cursor for digit.
6. Press the DISP key to close the menu and display the data screen.
Minimum
temperature
Maximum
temperature
To move the cursor
from minimum item
to maximum item,
use the Cursorpad (
).