Operator's Manual

9. INSTALLATION

9-2

9.2 Installation

Mounting considerations

The remote display can be installed on a desktop, on the underside of a table, or flush

mounted in a panel. When you select a mounting location, remember the following

points:

• The nominal viewing distance for the display unit is 0.6 m. Select a suitable mount-

ing location considering that distance.

• Locate the remote display away from exhaust pipes and vents.

• Select an installation location that is well ventilated.

• Locate the remote display where shock and vibration are minimal.

• Locate the remote display away from equipment which generates the electromag-

netic fields like a motor or generator.

• Allow enough maintenance space at the sides and rear of the remote display and

leave enough slack in cables to facilitate maintenance and servicing.

• Observe the compass safe distances (see page ii) to prevent the interference to a

magnetic compass.

Flush mounting

See the outline drawing in the back of this manual.

1. Make a cutout in the mounting location using the template.

2. Make four pilot holes for self-tapping screws (3x20) in the mounting location.

3. Remove the hanger assembly from the remote display. Discard the hanger as-

sembly.

4. Remove the front panel from the remote display by unfastening the catches at the

rear of the panel by hands, in the order shown in the figure below.

127 ± 0.5 (5.00”)

130 ± 1 (5.12”)

110 ± 1 (4.33”)

110 ± 0.5 (4.33”)

Pilot hole (4 places)

4-R12