User's Manual

Radar FAR-NN3D
The
NN3D Server option allows user to share all available charts in MaxSea to NavNet3D.
Go to
MaxSea Menu's Options and choose NN3D Charts Server
Click on "Enable" to activate the NN3D Chart Server and select the type of data that will be shared
with NavNet 3D.
Note that a message warns you if TimeZero is not connected to a NN3D Network.
Routes & Marks Synchronization
This function is only available for MaxSea Explorer installed on your computer connected to NavNet 3D
network.
The Active Route is automatically synchronized:
 The active route is automatically synchronized in real time between MaxSea and every NavNet
3D MFDs.
Planning Routes and Marks are not automatically synchronized but
MaxSea offers the following option to exchange this data over the
network:
1. Right- Click on
MaxSea Menu and choose NN3D Synchronization. This option
will overwrite the Route and Waypoint database of the receiver (MaxSea or NavNet3D)
2. Right click on any routes or marks and choose "Send to NavNet3D". This will merge the
selected route or marks with the NavNet3D database.
Radar Signal processing Settings
Adjusting the CCRP (Consistent Common Reference Position).
Measurements from Own Ship (e.g. range rings, target range and bearing, cursor, tracking data)
should be made with respect to the CCRP (e.g. conning position). Facilities should be provided to
compensate for the offset between antenna position and the CCRP on installation. Where multiple
antennas are installed, there should be provision for applying different position offsets for each
antenna in the radar system. The offsets should be applied automatically when any Radar sensor is
selected.
For example:
CCRP position
GPS position
Radar position
Note that the reference
coordinates are situated at the
prow of the boat.
125