User's Manual

MaxSea TimeZero Recreational v2
is automatically switched when your boat crosses the line through the Waypoint
that is perpendicular to the active leg line
 Circle and Cross line: in this mode, the next Waypoint is automatically switched
if it enters the switching circle or crosses the line..
Switching Circle Radius: this option sets the radius of the switching circle and arrival alarm. This is
a global setting that affects all Waypoint in a route ( 66yd by default.)
Waypoint Switching Notification: when this option is checked, a notification will appear in the
status bar (on top of the screen) whenever the active Waypoint is automatically switched. A sound will
also be triggered if the option "Alarm and Notification Sound" is checked in the "Alarm" options.
End of Route Notification: when this option is checked, a notification will appear in the status bar
(on top of the screen) whenever the last Waypoint of a Route is reached. A sound will also be
triggered if the option "Alarm and Notification Sound" is checked in the "Alarm" options.
Intelligent Waypoint Centering: when this option is checked, the chart will automatically pan when
a route is being built.
Display XTE Alarm Lines: when this option is checked, a red and green dash line (respectively port
and starboard) will appear on each side of the active leg (when a route is activated). These lines are a
graphical representation of the Cross Track Alarm value (that can be setup in the Alarms Options).
Fuel: Fuel options are used to configure the display of estimated maximum fuel range calculations
within the TimeZero software. Fuel tank levels and fuel flow information come from NMEA2000 sensors
(or J1939 sensors that are converted to NMEA2000 data streams)
148