User's Manual

MaxSea TimeZero Recreational v2
 Alarm Zone: User can create Boundary Zones on the chart (using the "Boundary Area" tool
or by right clicking on the chart and select "Create -> Boundary Area") and then set them as
Alarm Zones by right clicking on them and selecting "Alarm". Once Boundary Alarms are
created, the "Alarm Zone" will blink on chart setting will define their behavior:
 OFF: No alarm will be triggered even if the boat enters in an Alarm Zone
 ON: An alarm will be triggered as soon as the boat enters in any Alarm Zone
 Progressive: When the boat reach the distance set in "Progressive Alarm Zone
Value" from any Alarm Zone, a notification will be displayed (to warn the user from
the proximity). When the boat enters any Alarm Zone, an alarm is triggered. Note
that a dedicated NavData ("Alarm Zone NavData") can be setup to display the
distance from the nearest Alarm zone at any Time.
 Depth Alarm: An alarm sounds when the vessel passes over water shallower than a
designated depth value.
 Depth alarm Value: enter a depth limit value for when alarm is activated (10 meters by
default).
 Sea Surface Alarm: select a location for temperature variation (over water, under water,
within and out of) to activate alarm and then enter temperature limits for when alarm is
activated.
 Speed Alarm: select a location for speed variation (over water, under water, within and out
of) to activate alarm and then enter speed limits for when alarm is activated.
 CPA/TCPA Alarm: (Closest Point of Approach/Time to Closest Point of Approach): An alarm
sounds when the vessel’s CPA/TCPA fall below the designated values.
 Proximity AIS Target Alarm : An alarm sounds when the vessel passes within a
designated distance from an AIS target.
 GuardZone Alarm Level: Set the sensitivity of the Radar Guard Alarm Zone (increase the
value to increase the sensitivity) from 1 to 4
 GuardZone Alarm In/Out: Sets if the Radar Guard Alarm Zone responds to echos entering
or leaving the Guard Zone
 Anchor Watch Alarm: An alarm sounds when the vessel strays a designated distance from
where the user set anchor. Note that you can enable/disable the Anchor Alarm by right
clicking directly on the Own Ship icon.
160