User's Manual

3-4. Auto Scroll ON or OFF – New with Model TZT9/14/BB v3.12

The TZT9/14/BB v3.12 program has another new setting option of Auto Scroll, which enables to scroll the Plotter, Radar,

and Sounder screen by placing a cursor at the edge of the screen. The following screenshots show the menu settings and

scroll motions.

Menu Settings

[Menu] – [General] – [Auto Scroll] – [ON]

Menu Settings

[Menu] – [General] – [Auto Scroll] – [OFF] (Default)

In this example, a cursor is placed at the left edge of the

Plotter screen, while the chart is automatically scrolled.

(You can see the [Center Vessel] icon.) To stop the scroll

motion, place the cursor away from the edge.

At default, the Auto Scroll mode is set to OFF. When a cursor

is placed at the edge of the screen, the chart is not scrolled.

3-5. Entering a Point

– New with Model TZTBB and TZT14 (External Touch Screen Mode) v3.12

Pushing the MCU002 joystick, [New Point] will be highlighted at default on the contextual menus. You can just press

[ENT] to enter the point.

Note:

This specification is for the TZTBB and TZT14 under the External Touch Screen Mode only. With the TZT9 and TZT14