User Manual
G
YRO
S
ENSOR
I
NSTALLATION
TROUBLESHOOTING
If you experience erratic gyro operation (drifting,
not holding well or inconsistent pirouette rate),
please follow the troubleshooting tips listed below.
1. Always verify that your model’s tail rotor control
and drive system are working correctly.
%LECTROMAGNETICINTERFERENCECOULD AFFECTTHE
gyro or tail rotor servo. Mount the gyro in a dif-
ferent location, away from the electronic speed
control, servos and drive motor.
4HETROUBLEMAYBECAUSEDBYVIBRATION6ERIFY
that your helicopter’s components are bal-
anced. If problems persist, try mounting the
gyro in a different location.
The gyro sensor should be mounted on a rigid
platform, at least 6in [152mm] away from a Ni-
tro Engine. It is not necessary to mount the gyro
near the main shaft of the helicopter but it is very
important that the mounting area chosen is rigid.
Please refer to your helicopter manufacturer’s in-
structions for recommended mounting locations.
Installing the gyro sensor
The GY701 is supplied with three 2mm Mounting
Pads. When mounting the gyro in a larger electric
or .50 through .91 size nitro helicopter we recom-
mend using a supplied 2mm Mounting Pad.
2mm Mounting Pads
Gyro Mount
Gyro Sensor
34