User Manual

G
OVERNOR
B
ASIC
S
ETTING
44
This sets the governor’s fundamental functions.
The menu (9) Servo limit point setting must be
set first.
(1) Start display
The editing menus are scrolled
by pushing the mode + or – key.
(2) Revolution setting [range: 1000
∼
3000
rpm]
Setting the main rotor revolution. This is calcu-
lated by engine revolution with the gear ratio of
the main shaft.
• Using by 3position switch
Make sure the display is changed to 1, 2, 3 by mov-
ing the switch. Set the desire RPM at each position
by pushing the data + or – key.
• Direct set by transmitter on Gov. mixing
Use default governor mixing as in the T14MZ and
T12FG functions, calibration of the 3 point first,
then direct RPM setting can be set after that.
Push MODE
+/– key