User Manual

M
OUNTING THE
M
AGNET AND
S
ENSOR
55
The center of the sensor is different from the
center of the sensor case so be careful when
mounting the sensor.
If the display is less than 60% when the
magnet is directly below the sensor, bring the
sensor closer to the magnet so that the 60%
or more is displayed. The magnet and sensor
gap criteria is approximately 1 to 2mm. If a
sensor output is not obtained even when the
sensor is brought close to the magnet, the
magnet and sensor center positions may have
changed.
Complete assembly of the sensor by securely
tightening the screws that were temporarily
tightened.
Recheck the sensor output.