User Manual
G
OVERNOR
S
PEED
S
ETTING
60
The GY701 is used by connecting the “rpm” input
to the governor speed setting channel of your sys-
tem. When using an independent governor on/off
switch, activate the “(6) Governor on/off switch”
funtion within the “Governor Basic Setting” section
earlier in this manual. (S.BUS connection only)
Direct set by transmitter on Gov. mixing
When governor mixing as in the T14MZ and
T12FG is used to switch the RPM of the rotor
head speed. The head speed can be switched
with each condition or the switch.
*For a description of the governor mixing, refer to
your transmitter’s manual.
Using by 3position switch
Set the RPM at each switch position in the “(2)
Revolution setting” menu within the “Gov-
ernor Basic Setting” section earlier in this
manual.
Speed setting precautions
s7HENTHESPEEDSETTINGCHANNELTRAVEL%0!!46
!&2ISSETTOORLESSPOINTSANDCANNOT
be set.
s4HEENGINEMAXIMUMSPEEDRANGELIMITSTHE
maximum speed setting.
s4EST FLY THE HELICOPTER WITHTHEGOVERNORTURNED
OFFANDTACH THEMAINROTOR20-WHILEIN HORI-
ZONALmIGHT4HISISTHEMAXIMUM20-THATCAN
be achieved with the engine and pitch setup that
you are using. Please set the governor maximum
SPEEDTOAPPROXIMATELY20-SLESSTHANMAX
20-%XAMPLE)F20-SISMAXTHENSET