User's Guide

Dimensions:

Operating Instructions

System arming

Press the Arm button once, siren one time and system is armed now. In case the system gets triggers,

siren five times. Trigger again, siren sound for 15 seconds.

System disarming

Press the Disarm button once, sire one time and system is disarmed. Now user can start the bike.

Panic mode

The system is armed state, press the Locate button once, the siren will sound for 15 seconds. Press the

Disarm button to stop the alarm, and the system remains an armed state.

Power save mode

The system will automatically enter the power save mode 24 hours after it’s been set to the armed

state. The system bypass remote control function. If someone touched the bike, the system would

wake up from power save mode immediately, siren five times. Trigger again, siren sound for 15

seconds.

Low battery alarm

When the battery is low, the red LED light blinking quickly.

Adjusting shock sensor sensitivity

Although the sensor is pre set from the factory, it may be necessary to adjust the sensitivity to suit

your specific needs.

Press and hold down button 3, while holding down, the siren will sound to correspond with the

current sensitivity setting, the siren sound once is level 1, (Minimum level 1), the siren sound 3 times

is level 3 (Maximum leave 3). Release the button followed by one siren to indicate the setting saved.

Arm/Lock Button

Locate Button

Disarm/

nlock

Button