Installation Guide
Installation
1
Placing the flooring
□ For best results, start unrolling at the entrance; finishing at the back. Using a wide push broom, push
any air out from center and work your way outward, side-to-side and length-to-length. Depending on the
temperature, product may expand or contract somewhat during this process. It is OK to park your car on
the flooring during this time.
2
Trimming and seaming the flooring
□ For custom fit, allow the product to relax in place before trimming around edges and corners.
□ After the product has been allowed to relax in place, if you choose to hold down edges or seams between
two universal floor covers, use an acrylic-based tape for vinyl or an acrylic-based pressure sensitive
adhesive (PSA) for vinyl to hold edges in place.