Operation Manual

21
... changing settings
A setting cannot be changed, a programme
starts.
 Wrong programme button pressed. Terminate the
programme (see chapter entitled “Terminating the
programme (Reset)”) and start all over again.
 You did not wait until programme ended.
... on the appliance
Lower spray arm rotates sluggishly.
 Spray arm blocked.
The door is difficult to open. *
 Child-proof lock is activated. The deactivation
instructions are at the back in the envelope.
* depending on model
Door cannot be closed.
 Door lock has been activated. To reset, close the
door with greater force.
Cover on the detergent dispenser cannot be
closed.
 Detergent dispenser overfilled or mechanism
blocked by sticky detergent residue.
Detergent residue in the detergent dispenser.
 Dispenser was damp when filled.
“Check water supply” display @ lights up.
 Tap turned off.
 Water supply interrupted.
 Supply hose kinked.
 Filter in the water supply blocked.
1 Switch off the appliance and pull out
the mains plug.
2 Turn off the tap.
3 Clean filter in the supply hose.
4 Reconnect power supply.
5 Turn on the tap.
6 Switch on the appliance.
 Water is left in the appliance at the end
of the programme.
 (“:ƒ…) Waste water hose
is blocked or kinked.
Filters blocked.
 (“:ƒ†) Waste water pump blocked,
cover on the waste water pump is not
locked in position
(see Waste water pump).
 Filters blocked.
 The programme has not yet ended. Wait until
programme ends (digital display indicates
‹:‹‹) or implement the “Reset” function.
Error code “:ƒƒ
 Filters 1Z are soiled or blocked.
Refill indicator for salt H and/or rinse-aid P
is not lit.
 Refill indicator/s switched off.
 Adequate salt/rinse-aid available.
Refill indicator for special salt H is lit.
 No salt.
Refill with special salt.
 Sensor does not detect salt tablets.
Use different special salt.
... during the wash cycle
Unusual foam formation.
 Handwash liquid in the rinse aid dispenser.
Spilled rinse aid causes excessive frothing,
therefore please remove with a cloth.
Appliance stops during the wash cycle.
 Power supply interrupted.
 Water supply interrupted.
Filling valves making striking noises
 Caused by the installation of the water line and
has no effect on the function of the machine.
Remedial action is not possible.
Knocking/rattling noise during rinsing
 Spray arm is striking utensils.
 Utensils not arranged correctly.