Operation Manual
6
Water softening system
To ensure good washing results, the dishwasher
requires soft water, i.e. containing low amounts of
lime, otherwise white limescale will be deposited on
the utensils and inner container.
Tap water above 9° Clarke must be softened. The
water is softened with salt (regeneration salt) in the
water softening system of the dishwasher.
The setting and therefore the required amount of salt
depends on the degree of hardness of your tap water
(see table).
Setting
The amount of salt dispensed can be set from •:‹‹ to
•:‹ˆ.
Salt is not required at the set value •:‹‹.
1 Find out about the hardness value of your tap
water. Your water utility company will help you
with this.
2 Set value can be found in the water hardness
table.
3 Open the door.
4 Switch on ON/OFF switch (.
5 Hold down programme button # and press
START button )" until •:‹.... is indicated on the
digital display.
6 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
To change the setting:
1 Press programme button 3.
Each time the button is pressed, the set value
increases by one level; when the value of •:‹ˆ
has been reached, the display jumps back
to •:‹‹ (off).
2 Press START button )".
The chosen setting has now been stored.
3 Close the door.
Water hardness table
¯¯
¯³
¯
¯´
¯
¯
¯±
¯Å
:DWHU
KDUGQHVV
YDOXH
&ODUNH
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW