Operation Manual

21
Pump *
* on applicable models
Larger remnants of food that have not been trapped by
the filters and have been left in the water can cause a
blockage in the pump. The water is no longer pumped
out of the dishwasher and it can be seen covering the
filter.
Proceed as follows:
First, always disconnect the appliance from the
power supply.
Ladle out as much water as possible.
Remove the filters 26 .
Undo the screw in the cover (Torx T 20) and remove
the cover.
Inspect the inside and remove any obstructions that
you find.
Re-insert the cover and screw down.
Re-insert the filters and screw down.
Torx T20
2
1
Fault finding
Resolving minor problems yourself
Experience has shown that you can resolve most
problems that arise during normal daily usage yourself,
without having to call out a service engineer. Not only
does this save costs, but it also means that the
appliance is available for use again that much sooner.
The following list of common occurrences and their
remedies should help you identify the causes of most
problems.
Problems ...
Attention
Remember: Repairs may be carried out by a technician
only. If a component has to be replaced, ensure that
only original spare parts are used. Improper repairs
or use of non-original spare parts may cause
considerable damage and put the user at considerable
risk.
... On Switching On
Wrong Language Selected
The following steps return you to the language
selection:
1. Switch off the device.
2. Switch on the device. Press the button M/OK
2
repeatedly until the language selection appears in the
display.
3. Select the language and confirm your selection.
The device does not start.
A fuse in the house is defect.
The device is not properly plugged in.
The device’s door is not closed properly.
The device’s door was closed without first
starting the programme.