Operation Manual

13
Reduce costs!
If your dishes are only moderately dirty, you may be
able to use less detergent than recommended.
If using washing tablets, please refer to the washing
tablets box where to place the tablets in the
appliance (e.g. in the cutlery basket, detergent
dispenser).
Close the detergent dispenser. Slide the dispenser
cover completely over the detergent compartment
(1) and then press down firmly (2) until the catch
“clicks” into position.
Close the detergent dispenser when the door is
completely open.
Close the detergent dispenser when the door is half
open.
During the washing cycle the cover of the detergent
dispenser is automatically opened and the detergent
is washed out. The cover is therefore open when the
programme ends.
auto 3in1
The use of so-called combined detergent products may
make the use of rinse aid and/or salt unnecessary.
There are currently several types of combined
detergent products available.
2in1: They contain detergent and rinse aid or salt
function.
3in1: They contain detergent, rinse aid and salt
function.
4in1: They contain a detergent, rinse-aid, salt
function and an additional glass protection
component.
In addition, other combined products with a comparable
effect are offered according to the manufacturer.
>>> Always check the type of detergent or combined
product which you are using!
Always follow the operating instructions or the
information on the packaging.
The rinse programme is automatically adjusted in order
to obtain the best possible rinsing and drying result.
Observe the following important information if using
combined cleaning products:
Regeneration salt is not required up to a water
hardness of 21_ dH (37_ fH, 26_ Clarke, 3.7 mmol/l)
only. No other settings on the appliance are required.
Salt is still required if the water hardness is above
21_ dH (37_ fH, 26_Clarke, 3.7 mmol/l). Fill the salt
dispenser with salt
25
and select setting 6 on the
water softening system.
If in doubt, please contact the detergent manufacturer,
especially if:
the utensils are very wet at the end of the
programme.
limescale forms.
Note
Optimum rinsing and drying results can be obtained by
using standard detergents in conjunction with separate
application of salt and rinse aid.
Observance of the operating instructions or information
on the packaging of the combined detergents
determines their effectiveness.