User Manual

3
Connect the monitor/LCD
Connect the Monitor/DVI/TV
Plug your monitor/DVI/TV cable into the monitor/DVI/TV connector on your
Graphic card. Make sure the other end of the monitor/DVI/TV cable is properly
connected to your monitor/DVI/TV.
" Before installing the Display driver, make sure your Windows 95/98/NT was
installed in VGA mode and functions properly.
" For Windows 95 systems, please install DirectX before attempting to use the
MPEG Movie Player.
" To use an AGP graphics card with NT4.0, you may need to re-install NT with
Service Pack 3 (SP3) or later version before installing the AGP card.
" If you are running Windows NT4.0, please note that some drivers are not
compatible with earlier releases of Windows NT. Consult your dealer or local
support to ensure you have the most recent releases for Windows NT and the
drivers.
Before You Begin
If your system is running Windows 95/98/NT, the New Hardware Found dialog box
will appear after restart. Select Driver from disk provided by hardware
manufacturer, click OK, then follow all on-screen instructions. If the New
Monitor Connector (Blue) DVI Host Receptacle Connector
Chapter 3 Software Installation
TV-Out Composite TV-Out S-Video