Instructions / Assembly

ManualsBrandsGama Sonic ManualsLighting & Ceiling FansSolar Lamp Post Installation Kit with EZ-Anchor

Introduction

Thank you for your purchase. GAMA SONIC® has been recognized as a

worldwide leader in the lighting industry for over 20 years. The company also

offers unique multi-purpose rechargeable products that range from party lights

to emergency lighting products.

For technical assistance and more information call our Toll Free number:

800-835-4113 (only within the US).

Visit our website or download the latest version of your instruction manual:

www.gamasonic.com Or www.gamasonic.com/user-guides

EZ Lamp Post Mounting Accessory

Instruction Manual

Model: GS-3

Summary of content (4 pages)

PAGE 1
EZ Lamp Post Mounting Accessory Instruction Manual Model: GS-3 Introduction Thank you for your purchase. GAMA SONIC® has been recognized as a worldwide leader in the lighting industry for over 20 years. The company also offers unique multi-purpose rechargeable products that range from party lights to emergency lighting products. For technical assistance and more information call our Toll Free number: 800-835-4113 (only within the US).
PAGE 2
NOTE: The GS-3 is built to support the Gama Sonic solar lamp post with single head units that are mounted on a firm base. It is recommended that all double and triple head units be secured into hard floor, such as: cement or hardwood. Using our GS-3 where the soil is not firm enough, and/or for double or triple head solar lamp posts, is not recommended and the user shall bear the sole responsibility for any such use. NOTE: The lamp post mounting system will go approximately 16” into the ground.
PAGE 3
Read the instruction manual carefully to obtain the best results from your purchase. Unpack and identify the following parts: The EZ lamp post mounting system will make installation of your lamp post a carefree experience. NOTE: The following steps are for reference only. Consult your local hardware store for the best installation method for your particular surface.
PAGE 4
3. Installation: 1. Remove Parts F1 – F3 from the Auger stake (B) and set aside. 2. Place the Adaptor (A) on to the Auger stake (B) 3. Place the Turning bar (D) in the hole through the Adaptor and the Auger stake, Fig. 1 4. Place Adaptor mounting system in desired location and apply downward pressure while turning the Turning bar clock wise. 5. Occasionally check the Level Tool on the Adaptor to ensure your auger stake is straight, see part A. 6.