Instructions / Assembly

3. Installation:

1. Remove Parts F1 – F3 from the Auger stake (B) and set aside.

2. Place the Adaptor (A) on to the Auger stake (B)

3. Place the Turning bar (D) in the hole through the Adaptor and the

Auger stake, Fig. 1

4. Place Adaptor mounting system in desired location and apply

downward pressure while turning the Turning bar clock wise.

5. Occasionally check the Level Tool on the Adaptor to ensure your auger

stake is straight, see part A.

6. Stop turning once the ground stop ring has reached ground level, see

part B.

7. Remove the Turning Bar and replace with the metal sleeve (part F3).

8. Replace alternate screw (part F1) and washers (part F2) through

sleeve and secure with wing nut, Fig 2.

9. Place the small stakes (Part C) in appropriate Adaptor holes and

hammer into the ground for additional strength.

Ground adaptor installation is complete and ready for your Gama Sonic lamp

post installation.

1. Remove bolt caps (part E) and washers (part F4) from Adaptor bolts

(part A).

2. Slide lamp post base over Adaptor bolts.

3. Replace washers (part F4) and bolt caps (part E) to secure the base to

the Adaptor.

4. See instructions for solar lamp post installation to install the remaining

parts of your lamp post.