Installation Guide

8
8
FIG. 1
Motor mounting plate
must be fastened to
wooden joists in the
building framing. Do
not fasten to drywall,
particle board, plaster
or other such
materials.
!
WARNING
8
Motor mounting plate
must be fastened to
wooden joists in the
building framing. Do
not fasten to drywall,
particle board, plaster
or other such
materials.
!
WARNING
Step 2 - Install the motor mounting plate to the ceiling
 
pencil the four locations where the lag bolts will be fastened.
 
hole saw drill bit (U) or cut away the drywall with a utility knife to obtain an unobstructed
view of the width of the joists so the exact center can easily be determined (covered
ceilings only). It may be necessary to again use the motor mounting template and a
pencil to mark where to wood screws are to be fastened.
 
joists.
 

located - prior to fastening to the joists. Ensure your motor mounting plate
is rotated properly before placing the motor mounting plate on ceiling.
(SEE ILLUSTRATIONS ON PAGE 7)
 
nuts (Q) Place the motor mounting plate (A) without the motor hoist (B) attached over
the screw holes. (To remove the motor hoist from the motor mounting plate loosen (it is

slide off the motor hoist.)
 
motor mounting plate is securely fastened. (SEE FIG. 1)