Owner's manual

13
TOLL FREE HELP LINE 1 855 691 5969
MODEL Y4007
MINI CULTIVATOR AND DETHATHER
MAINTENANCE
STEPS FOR WORKING ON EQUIPMENT
1. Make sure engine switch is in the off posi on
2. Disconnect the Spark Plug wire from the Spark Plug
3. Secure the Spark Plug wire away from the Spark Plug itself and other metal parts. Make sure this is done to
prevent wire from arching with Plug
4. Replace or repair parts on your unit
5. Once complete, make sure all parts are secure and fit correctly
NOTE: All parts must come from the factory or our authorized Service Center. Never use parts that are not
designed specifically for the unit
6. Once co
mplete, rea
ach the Spark Plug wire
MINI CULTIVATOR MAINTENANCE
1. The unit Transmission Case comes with grease that has been packed at the factory. It is recommended by the
factory that the grease level be checked by a qualified service professional to ensure that the grease level is
accurate. If grease is needed, add only molylithium type grease only if the level is below the top of the gears. DO
NOT OVERFILL!
2. Make sure all screws, nuts and bolts are secure and
ght
3. Store the unit in a safe cool environment for c
old weather op
on. Transferring the unit from cold to warm
environments can cause cond
on build up
ENGINE MAINTENANCE
1. Cooling Fins, Air Vents and linkages must always be kept free of dirt and debris. Always make sure they are clean
before each
me you use the unit
2. Never Run this unit without the engine Air Filter properly installed. Engine failure and add onal wear may occur
if air cleaner is not installed properly
3. Service the Air Filter every 90 days or er 20 or more hours of opera on. Clean Air filter on a daily basis in
PRACTICE SAFETY AT ALL TIMES!!!! ENGINE MUST BE TURNED OFF AND ALLOWED TO COOL AND SPARK
PLUG WIRE MUST BE DISCONNECTED WHENEVER WORKING ON UNIT FOR MAINTENANCE OR REPAIR
TO PREVENT ACCIDENTAL STARTING:
ENGINE MUST BE TURNED OFF AND ALLOWED TO COOL AND SPARK PLUG WIRE MUST BE DISCONNECTED
BEFORE CHECKING OR ADJUSTING ENGINE
MUFFLER AND NEARBY AREA TEMPERATURES MAY EXCEED 150° F (65° C). AVOID THESE AREAS
ALWAYS CHECK UNIT FOR LOOSE SCREWS AND BOLTS. KEEP CONNECTIONS SECURE
NEVER STORE UNIT INDOORS WITH FUEL IN THE TANK. FUEL VAPORS MAY BE PRESENT
ONLY ADULTS SHOULD BE ALLOWED TO USE UNIT OR PREFORM MAINTENANCE ON IT
ENGINE MUST BE TURN
ED OFF
AND SPARK PLUG WIRE DISCONNECTED BEFORE ANY REPAIRS OR
MAINTENANCE IS PREFORMED ON UNIT
CAUTION!
should be cleaned.