Owner's manual
15
TOLL FREE HELP LINE 1 855 691 5969
MODEL Y4007
MINI CULTIVATOR AND DETHATHER
SPARK PLUG
THE RECOMMENDED SPARK PLUG FOR THIS UNIT IS A5RTC
1. Always check the Spark Plug at the beginning of each season
2. Disconnect Spark Plug Cap and clean any debris or dirt from around the Spark Plug area
3. Exam the Spark Plug and replace if any of the following have occurred:
a. P
ed Electrodes
b. Burned Electrodes
c. Cracked Porcelain
d. Or Deposits around Spark Plug
4. A
er cleaning or replacing, reseat Spark Plug and ghten securely.... rea ach Spark
Plug wire
5. When reinstalling original Spark Plug,
ghten an add onal 1/2 turn
6. When replacing Spark Plug, adjust Spark Plug Gap to .028" and
ghten an add onal 1/8 to 1/4 turn
NOTE: A loose Spark Plug can overheat and damage your engine. Over
htening too much could damage the
threads in the cylinder head
CARBURETOR
NEVER TAMPER WITH THE FACTORY SETTING OF THE CARBURETOR
TINE REMOVAL AND INSTALLATION
REMOVING TINES
1. Remove the co
er pins from each end of the ne sha
2. Slide each of the four
nes off the
INSTALLING TINES
1. First slide the inside
nes onto both ends of the ne sh Inside nes are stamped with a either a le er "B" or "C"
2. Slide the outside
nes onto the ne sha The outside nes are stamped with either the letter "A" or "D"
3. The
nes should be installed so that they are aligned in a sequence of "A,B.C.D" and should be po oned in that
order from le
to right when viewed from the user's po on of the mini cul vator
4. Make sure the hub collars on both the right and
pair of nes face each other so that there is adequate spacing
b
etween the
ne blades (SEE FIGURE 10)
5. Reinsert the co
er pins back on each side of the ne sha to lock the nes into place
FIGURE 10 FRONT VIEW
A
B
C
D
Hub Collars
Cotter Pin
Cotter Pin
NGK Equivalent plug number CR5HSA